Bissell CROSSWAVE OMNIFORCE EDGE 3933 Series Vacuum Cleaner Manual

The Bissell CROSSWAVE OMNIFORCE EDGE 3933 is a versatile vacuum cleaner designed for multi-surface cleaning, including carpets, rugs, and hard floors. It features a dual-action brush roll, multi-surface cleaning solution, and a convenient self-cleaning cycle. Below are key sections for safety, features, installation, setup, operation, and troubleshooting.

1. Features at a Glance 2. Installation 3. First-Time Setup 4. Specifications 5. Controls and Settings 6. Connecting Devices 7. Using the Vacuum Cleaner 8. Maintenance and Care 9. Regulatory Information 10. Troubleshooting

Features at a Glance

Key components: Dual-action brush roll, multi-surface cleaning solution, self-cleaning cycle, easy-to-empty dirt tank.

Feature	Description
Dual-action brush roll	Cleans both carpets and hard floors effectively
Multi-surface cleaning solution	Formulated for optimal cleaning on various surfaces
Self-cleaning cycle	Helps maintain brush roll cleanliness
Easy-to-empty dirt tank	Convenient disposal of collected dirt and debris
Lightweight design	Easy to maneuver around the home
Edge cleaning feature	Reaches corners and edges for thorough cleaning

Installation

Unpack and inspect contents. Ensure all parts are included.

Attach the handle to the main body of the vacuum.
Insert the dirt tank until it clicks into place.
Fill the clean water tank with the recommended cleaning solution.
Plug into a power outlet.

WARNING! Ensure the vacuum is unplugged when assembling or disassembling.

First-Time Setup

Power on the vacuum; follow the setup instructions.

Fill the clean water tank with the appropriate solution.
Check that the brush roll is properly installed.
Test the vacuum on a small area to ensure proper operation.

CAUTION! Do not overfill the water tank; follow the fill line.

Specifications

Model: Bissell CROSSWAVE OMNIFORCE EDGE 3933.
Weight: 11 lbs.
Power Source: 120V AC.
Cleaning Path Width: 12 inches.
Tank Capacity: 0.5 gallons.
Brush Roll Type: Dual-action.
Cleaning Solution: Multi-surface formula.
Warranty: 2 years limited.

Controls and Settings

Power button located on the handle. Use the mode selector to switch between cleaning modes.

Cleaning Modes: Hard floor, carpet, and self-cleaning mode.

Adjust the solution dispensing according to the surface being cleaned.

Connecting Devices

Ensure the vacuum is unplugged before connecting any accessories.

Attach the cleaning solution tank securely.
Ensure the brush roll is properly installed.
Connect any additional attachments as needed.

Tip: Always check for compatibility with attachments before use.

Using the Vacuum Cleaner

Supports multi-surface cleaning.

Power on the vacuum and select the desired cleaning mode.
Move the vacuum forward and backward to clean the surface.
Use the self-cleaning mode after use to maintain the brush roll.
Empty the dirt tank as needed.

WARNING! Do not use on wet surfaces unless in the appropriate mode.

Maintenance and Care

Regularly clean the brush roll and empty the dirt tank.

CAUTION! Unplug the vacuum before performing maintenance.

Regulatory Information

This vacuum cleaner complies with all applicable safety standards. For support, visit www.bissell.com or contact customer service.

Troubleshooting

Symptom	Possible Cause	Corrective Action
Vacuum won't turn on	Power connection	Check power outlet and cord connection.
No suction	Clogged hose/dirt tank	Check for blockages and empty dirt tank.
Brush roll not spinning	Brush roll jammed	Clear any debris and ensure brush roll is installed correctly.
Water leaking	Tank not secured	Ensure the clean water tank is properly attached.

Reset: Unplug for 10 seconds and plug back in.

Service: For assistance, contact Bissell customer service.